Now showing 1 - 2 of 2
  • Publication
    Effect of polyethylene glycol and sodium dodecyl sulphate on microstructure and self-cleaning properties of graphene oxide/TiO2 thin film
    In this study, a sol gel procedure for preparation of TiO2 thin films with graphene oxide (GO) was developed. The effect of PEG and SDS addition on the microstructure of the films as well as the photocatalytic activity of the thin film was also investigated. The morphology and surface structure of the films were studied by SEM and AFM while the photocatalytic activity of the films was analyzed by measuring the degradation of methylene blue under sunlight irradiation using UV-Vis spectrophotometer. It was found that GO/TiO2 thin film with PEG shows a smaller and porous particle while GO/TiO2 thin film with SDS formed a very smooth surface and very fine particles. Therefore, in AFM analysis reveals that surface roughness decreases with the addition of PEG and SDS. Finally, the photocatalytic activity showed that GO/TiO2 thin film with SDS have the most effective self-cleaning property which degrade 64% of methylene blue that act as model of contaminants.
      1
  • Publication
    Synthesis of Zn/TiO2 Thin Films for Self-Cleaning Applications
    ( 2022-07-01) ;
    Abidin A.S.Z.
    ;
    Azani A.
    ;
    ; ; ; ;
    Sandu A.V.
    ;
    Vizureanu P.
    ;
    Kaczmarek L.
    ;
    Garus S.
    ;
    Garus J.
    Titanium dioxide (TiO2) thin film has been widely used in semiconductor applications. The surface modification on TiO2 has been done by adding zinc (Zn) in order to improve surface wettability and enhance the photocatalysis efficiency for solar cell applications. Self-cleaning technology is very important to sustain the efficiency of the solar cell and reduce the cost of the maintenance of the solar cell. In this work, the sol–gel method was used due to the economic factor and its best efficiency. The sol–gel method is a wet chemical technique involving several steps, such as hydrolysis and polycondensation, gelation, aging, drying, densification, and crystallization. The X-Ray diffraction pattern shows that anatase and rutile phases were detected at 2θ = 36.3864◦. It was clearly seen at 4% Zn-doped TiO2 annealed at 400◦C that due to the increment of Zn concentration, the phase transformed from the anatase phase to the rutile phase at high temperature. The scanning electron microscope micrograph shows that Zn concentration affects grain size. The water contact angle produced when 4% Zn-doped TiO2 was annealed at 300◦C, was 18◦ — higher than in the sample of 4% Zn-doped TiO2 annealed at 400◦C. These results clearly showed that the dopant concentration and the annealing temperature influence the properties of TiO2 for a self-cleaning application.
      2