Muzammil Jusoh
Thumbnail Image
Preferred name
Muzammil Jusoh
Official Name
Muzammil, Jusoh
Alternative Name
Jusoh, M.
Jusoh, Muzammil
Jusoh, Muzammi
Jusoh, Muzammir
Main Affiliation
Scopus Author ID
24483755700
Researcher ID
Z-1156-2019

Research Output

Filters

97
Reset filters

Settings
Now showing 1 - 10 of 97
  • Publication
    A dual band antenna design for future millimeter wave wireless communication at 24.25 GHz and 38 GHz
    ( 2017-10-10)
    Daud N.N.
    ;
    Muzammil Jusoh
    ;
    Hasliza A Rahim @ Samsuddin
    ;
    Rozmie Razif Othman
    ;
    Sapabathy T.
    ;
    Mohd Nizam Osman
    ;
    Yassin M.N.M.
    ;
    Kamarudin M.R.
    This paper proposes a dual band antenna for future millimeter wave wireless communication. The performance of this dual band antenna is analyzed in term of reflection coefficient when some of the length of the patch antenna was adjustable, overall gain and total efficiency for both frequencies respectively. The size of this presented patch antenna is 4.9 × 7.6 mm2. The dual band antenna was fabricated on a RTRogers5880 with a dielectric constant of £=2.2 and thickness of the substrate is 0.127 mm. The simulated result obtained the reflection coefficient as a requirement of the antenna which is not less than -10 dB for 24.25 GHz and 38 GHz that capable to cover 5G applications. The proposed antenna has achieved a maximum gain up to 5.5 dBi and 4.5 dBi at desired frequencies respectively. All design and simulation are carried out using CST Microwave Studio software. The proposed antenna design could be suitable to be applied as a device to the 5G wireless system.
  • Publication
    Compact ultra-wideband monopole antenna loaded with metamaterial
    ( 2020-02-01)
    Al-bawri S.S.
    ;
    Goh H.H.
    ;
    Islam M.S.
    ;
    Wong H.Y.
    ;
    Jamlos M.F.
    ;
    Narbudowicz A.
    ;
    Muzammil Jusoh
    ;
    Thennarasan Sabapathy
    ;
    Khan, Rizwan D.
    ;
    Islam M.T.
    A printed compact monopole antenna based on a single negative (SNG) metamaterial is proposed for ultra-wideband (UWB) applications. A low-profile, key-shaped structure forms the radiating monopole and is loaded with metamaterial unit cells with negative permittivity and more than 1.5 GHz bandwidth of near-zero refractive index (NZRI) property. The antenna offers a wide bandwidth from 3.08 to 14.1 GHz and an average gain of 4.54 dBi, with a peak gain of 6.12 dBi; this is in contrast to the poor performance when metamaterial is not used. Moreover, the maximum obtained radiation efficiency is 97%. A reasonable agreement between simulation and experiments is realized, demonstrating that the proposed antenna can operate over a wide bandwidth with symmetric split-ring resonator (SSRR) metamaterial structures and compact size of 14.5 × 22 mm2 (0.148 λ0 × 0.226 λ0) with respect to the lowest operating frequency.
  • Publication
    Critical Review: Adaptive Pole Assignment PID Controller on DC-DC Converters
    ( 2020-03-20)
    Husna A.W.N.
    ;
    Mohd Hafizuddin Mat
    ;
    Mohd Najib Mohd Yasin
    ;
    Muzammil Jusoh
    ;
    Mohd Irwan Yusoff
    ;
    Mohamad Shukor Abdul Rahim
    ;
    Esa S.M.
    Recently, control usages of DC-DC converters have been widely investigated particularly in renewable energy; as the primary sources. Discovering the most appropriate control method to be applied in DC-DC converter topologies is the most significant interest of research and development in this field. Thus, the review is carried out in selecting a control method that capable to improve the functioning of the converters as well as reducing the effect of disturbances and load variances.
  • Publication
    A multilayered acoustic signal generator for low power energy harvesting
    ( 2017-10-10)
    Awal M.R.
    ;
    Muzammil Jusoh
    ;
    Hasliza A Rahim @ Samsuddin
    ;
    Thennarasan Sabapathy
    ;
    Mohamed Nasrun Osman
    ;
    Mohd Ilman Jais
    ;
    Kamarudin M.R.
    This paper presents the design and analysis of a multilayer cantilever to harvest vibration energy by generating acoustic signal. To do so, a five layer configuration is used to design the cantilever. Lead Zirconate Titanate (PZT-8), Stainless Steel 405 Annealed, Aluminum and Zinc Oxide are used to develop the layers. Water is used as the medium to analyze the sound propagation pattern. Sound Pressure Level, displacements and electric potential of the cantilever are analyzed along with other parameters. From the results, it is evident that, the proposed cantilever can propagate sound within a range of 78.7 dB to 73.4 dB in a 50 mm spherical distance.
  • Publication
    A brief review of the EMF interaction: Metal implantation and biological tissues
    ( 2017-01-01)
    Mohd Hafizuddin Mat
    ;
    Muzammil Jusoh
    ;
    Hasliza A Rahim @ Samsuddin
    ;
    Mohd Irwan Yusoff
    In analyzing the near field for a device, such as a mobile phone used in close proximity to tissues, it is difficult to predict the electromagnetic field (EMF) and other characteristics, since certain parts of the mobile phone scatter and reflect the EMF. Moreover, the absorption of EMF in the lossy tissues mitigates as the radio frequency (RF) energy is absorbed by the tissue. In order to minimize the heating effect on human tissue caused by this absorption of RF energy by the human body, all communications equipment (CE) must comply with the guidelines that established the maximum power output of devices. Though RF emissions from CE are carefully measured, the probability exists that the RF characteristics are reformed somewhat when tissue that illuminated by RF energy embedded with implant, thereby increasing the specific absorption rate (SAR). The SAR is the fundamental metric for specifying RF absorption by tissues and it can be calculated at any location in the tissue.
  • Publication
    Metamaterial cell-based superstrate towards bandwidth and gain enhancement of quad-band CPW-fed antenna for wireless applications
    ( 2020-01-02)
    Al-Bawri S.S.
    ;
    Islam M.S.
    ;
    Wong H.Y.
    ;
    Jamlos M.F.
    ;
    Narbudowicz A.
    ;
    Muzammil Jusoh
    ;
    Thennarasan Sabapathy
    ;
    Islam M.T.
    A multiband coplanar waveguide (CPW)-fed antenna loaded with metamaterial unit cell for GSM900, WLAN, LTE-A, and 5G Wi-Fi applications is presented in this paper. The proposed metamaterial structure is a combination of various symmetric split-ring resonators (SSRR) and its characteristics were investigated for two major axes directions at (x and y-axis) wave propagation through the material. For x-axis wave propagation, it indicates a wide range of negative refractive index in the frequency span of 2–8.5 GHz. For y-axis wave propagation, it shows more than 2 GHz bandwidth of near-zero refractive index (NZRI) property. Two categories of the proposed metamaterial plane were applied to enhance the bandwidth and gain. The measured reflection coefficient (S11) demonstrated significant bandwidths increase at the upper bands by 4.92–6.49 GHz and 3.251–4.324 GHz, considered as a rise of 71.4% and 168%, respectively, against the proposed antenna without using metamaterial. Besides being high bandwidth achieving, the proposed antenna radiates bi-directionally with 95% as the maximum radiation efficiency. Moreover, the maximum measured gain reaches 6.74 dBi by a 92.57% improvement compared with the antenna without using metamaterial. The simulation and measurement results of the proposed antenna show good agreement.
  • Publication
    Decagonal c-shaped csrr textile-based metamaterial for microwave applications
    ( 2022-01-01)
    Hossain K.
    ;
    Thennarasan Sabapathy
    ;
    Muzammil Jusoh
    ;
    Soh Ping Jack
    ;
    Al-Bawri S.S.
    ;
    Osman M.N.
    ;
    Hasliza A Rahim @ Samsuddin
    ;
    Torrungrueng D.
    ;
    Akkaraekthalin P.
    This paper introduces a decagonal C-shaped complementary splitring resonator (CSRR) textile-based metamaterial (MTM). The overall size of the proposed sub-wavelength MTM unit cell is 0.28λ0 ×0.255λ0 at 3 GHz. Its stopband behaviour was first studied prior analysing the negative index properties of the proposed MTM. It is worth noting that in this work a unique way the experiments were completed. For both simulations andmeasurements, the proposed MTM exhibited negative-permittivity and negative-refractive index characteristics with an average bandwidth of more than 3 GHz (considering 1.7 to 8.2 GHz as the measurements were carried out within this range). In simulations, the MTM exhibited negative-permittivity properties within the range of 1.7 to 7.52 GHz and 7.96 to 8.2 GHz; and negative-refractive index from 1.7 to 2.23 GHz and 2.33 to 5.09 GHz and 5.63 to 7.45 GHz. When measured from 1.7 to 8.2 GHz, negative-permittivity and negative-refractive index characteristics are exhibited throughout an average bandwidth of more than 3 GHz. Similarly, the transmission coefficient attained in simulations and measurements indicated about 3 GHz of bandwidth, from 1.7 to 3.88 GHz and from 6.68 to 7.4 GHz. The satisfactory agreement between simulations and experiments indicates the potential of the proposed MTM for microwave applications.
  • Publication
    Reliable Early Breast Cancer Detection using Artificial Neural Network for Small Data Set
    ( 2021-03-01)
    Vijayasarveswari V.
    ;
    Muzammil Jusoh
    ;
    Thennarasan Sabapathy
    ;
    Rafikha Aliana A Raof
    ;
    Khatun S.
    ;
    Iszaidy I.
    This paper proposes a breast cancer detection module using Artificial Neural Network for small data set. The developed system consists of hardware and software. Hardware included UWB transceiver and a pair of home-made directional sensor/antenna. The software included a Graphical User Interface (GUI) and k-fold based feed-forward back propagation Neural Network module to detect the tumor existence, size and location along with soft interface between software and hardware. Forward scattering technique is used by placing two sensors diagonally opposite sides of a breast phantom. UWB pulses are transmitted from one side of phantom and received from other side, controlled by the software interface in PC environment. Firstly feed forward backpropagation neural network (FFBNN) is developed. Then, k-fold is combined with developed FFBNN for testing purpose. Four data sets are created where contains 125, 95, 65 and 30 data samples in 1st,2nd,3rd and 4th data set respectively. Collected received signals were then fed into the NN module for training, testing and validation. The process is done for all data sets separately. The system exhibits detection efficiency of tumor existence, location (x, y, z), and size were approximately 87.72%, 87.24%, 83.93% and 80.51% for 1st, 2nd, 3rd and 4th data set respectively. The proposed module is very practical with low-cost and user friendly. The developed breast cancer detection module can be used for large data samples as well as for minimum data samples.
  • Publication
    Investigation on the Effect of Deflected Ground Structure in Multi-Direction Steerable Antenna for WSN
    ( 2020-03-20)
    Zainudin N.A.F.M.
    ;
    Osman M.N.
    ;
    Thennarasan Sabapathy
    ;
    Muzammil Jusoh
    In this paper, a multi-direction steerable radiation pattern antenna is designed and investigated, which operates at 2.45 GHz frequency. The radiation pattern reconfigurable is achieved by locating four parasitic elements surrounding the driving element at the centre. The artificial switches, are currently used to replace the ideal diode for proof of the concept, are inserted at the specific position on the parasitic element. By controlling the state ON/OFF of the switches, the parasitic is grounded via shorting pin, thus realizing the beam steering to be directed into four direction angles; right, left, upwards and downwards. In this research, an investigation on the effect of deflected ground plane on the steering angles has been carried out. With minimum numbers of switches deployed, the proposed antenna is a potential candidate to serve as a transmitting element in WSN applications.
  • Publication
    Steerable higher order mode dielectric resonator antenna with parasitic elements for 5G applications
    ( 2017)
    Nor Hidayu Shahadan
    ;
    Mohd Haizal Jamaluddin
    ;
    Muhammad Ramlee Kamarudin
    ;
    Yoshihide Yamada
    ;
    Mohsen Khalily
    ;
    Muzammil Jusoh
    ;
    Samsul Haimi Dahlan
    This paper presents the findings of a steerable higher order mode (TEy 1δ3) dielectric resonator antenna with parasitic elements. The beam steering was successfully achieved by switching the termination capacitor on the parasitic element. In this light, all of the dielectric resonator antennas (DRAs) have the same dielectric permittivity similar to that of ten and excited by a 50 microstrip with a narrow aperture. The effect of the mutual coupling on the radiation pattern and the reflection coefficient, as well as the array factor, was investigated clearly using MATLAB version 2014b and ANSYS HFSS version 16. As the result, the antenna beam of the proposed DRA array managed to steer from −32◦ to +32◦ at 15 GHz. furthermore, the measured antenna array showed the maximum gain of 9.25 dBi and the reflection coefficients which are less than −10 dB with the bandwidth more than 1.3 GHz, which is viewed as desirable for device-to-device communication in 5G Internet of Things applications.