Journal Articles

Permanent URI for this collection

https://hdl.handle.net/20.500.14170/1818

Browse

Browsing Journal Articles by Author "Ala’eddin A. SAIF"
  • Publication
    Frequency dependent electrical properties of ferroelectric Ba₀.₈Sr₀.₂TiO₃ thin film
    ( 1970)
    Ala’eddin A. SAIF
    ;
    Zul Azhar Zahid Jamal
    ;
    Zaliman Sauli
    ;
    Prabakaran A/L Poopalan
    The frequency dependent electrical parameters, such as impedance, electric modulus, dielectric constant and AC conductivity for ferroelectric Ba₀.₈Sr₀.₂TiO₃ thin film have been investigated within the range of 1 Hz and 106 Hz at room temperature. Z* plane shows two regions corresponding to the bulk mechanism and the distribution of the grain boundaries-electrodes process. M" versus frequency plot reveals a relaxation peak, which is not observed in the ε″ plot and it has been found that this peak is a non-Debye-type. The frequency dependent conductivity plot shows three regions of conduction processes, i. e., a low-frequency region due to DC conduction, a mid-frequency region due to translational hopping motions and a high-frequency region due to localized hopping and/or reorientational motion.http://dx.doi.org/10.5755/j01.ms.17.2.490
      4  18
  • Publication
    Sol-gel synthesis and characterization of Ba1-xGdxTiO3+δ thin films on SiO2/Si substrates using spin-coating technique
    ( 2017)
    Yen Chin TEH
    ;
    Ala’eddin A. SAIF
    ;
    Prabakaran A/L Poopalan
    Ba1-xGdxTiO3+δ, at x = 0, 0.05, 0.1, 0.15, 0.2, (BGT) thin films have been fabricated on SiO2/Si substrate using Sol-Gel method. The microstructure and surface morphology of the fabricated films have been investigated using X-ray diffraction (XRD) and atomic force microscopy (AFM). The XRD results show that the fabricated films are crystalline with perovskite structure. There is a shifting of the preferred peak at 31.5o to a higher angle as the doping ratio increases suggesting a distortion lattice exists in the films, which could be due to the substitution of Gd3+ ions into Ba-site. The decreasing of lattice constants confirms the substitution of Gd3+ in BaTiO3 lattice structure. The microstrain and dislocation density are found to be increased with the increase of Gd3+ doping, which attributed to the reduction of lattice volume that due to the ionic size mismatch effect. The AFM results show decreasing trend in both average grain size and roughness parameters. Therefore, the microstructure and surface morphology of BGT samples is strongly dependent on the Gd3+ doping concentration that mainly due to the difference ionic radius substitution.