Effect of electrospinning parameters on the morphological and thermal properties of ABSENR electrospun fibres

The electrospun of the Acrylonitrile-butadiene-styrene (ABS) blend with epoxidized natural rubber (ENR) is fabricated using the electrospinning technique. Research shows that ABS/ENR electrospun fibres have not been studied. The effects of electrospinning parameters were investigated to determine a significant effect on the microstructure, surface roughness, fibre diameter, and fibre distribution of the electrospun membranes. Sample preparation is made straightforwardly by dissolving ABS and ENR in acetone solvent using a magnetic stirrer. In this research, there are two solution parameters being studied: the ABS/ENR solution concentration (15 to 25 wt.%) and the ratio of ENR (100:0, 70:30, 50:50). Meanwhile, process parameters that are being studied are applied voltage (15 kV to 30 kV) and distance from syringe tip to collector (5cm to 15cm). FTIR results showed that hydrogen bond interaction occurs between ABS and ENR. According to the SEM images, micrometre and sub-micrometre fibres with a smooth surface and bead formation were produced at a concentration of 25%, a ratio of 70:30, a voltage of 30kV, and a distance of 15cm. The diameter of electrospun fibres increases with increasing solution concentration, ranging from 400 nm to 4.5 μm. The diameter of the electrospun fibres decreased with the addition of ENR, increasing voltage, and tip-to-collector distance. TGA results showed that ABS/ENR blends gave higher degradation temperature (393.7°C) than pure ABS (368.8°C), which enhanced thermal stability.