Publication:
Experimental investigation of machining parameter on hole quality in drilling Ti-6Al-4V

Simple item page
cris.virtual.department Universiti Malaysia Perlis
cris.virtual.department Universiti Malaysia Perlis
cris.virtual.department Universiti Malaysia Perlis
cris.virtualsource.department 6097549a-8ce8-49af-a232-6ba7eedf0a11
cris.virtualsource.department e816b4d8-6642-4b9b-9aac-3929772b89aa
cris.virtualsource.department 25454a46-858b-4b28-94dc-1b6bd940c8c4
dc.contributor.author R A Rashid
dc.contributor.author Muhamad Nasir Murad
dc.contributor.author Roshaliza Hamidon
dc.contributor.author Shafizan Shariffuddin
dc.contributor.author Ali, Mohamed Ashraf Mahboob
dc.date.accessioned 2025-06-06T00:34:46Z
dc.date.available 2025-06-06T00:34:46Z
dc.date.issued 2020
dc.description.abstract Titanium alloys (Ti-6Al-4V) are greatly recommended for high performance applications because of their outstanding properties such as low weight, high corrosion resistance and high strength. However, drilling Ti-6Al-4V generates high cutting temperature, especially during high speed drilling (HSD), increased the chemical reactivity of Ti-6Al-4V, thus leading to poor hole quality. High cutting speed increases the temperature during the drilling process, therefore, it is important to consider this factor to achieve better hole quality. This study focuses on the correlation of machining parameter and the quality of the hole produced in terms of hole diameter, roundness and surface roughness. The experiment was conducted using a 6 mm diameter of coated (TiAlN) carbide tool under MQL and MQCL conditions with varying cutting speeds of 65, 75, 85 and 95 m/min and constant 0.02 mm/rev feed rate.
dc.identifier.doi 10.1088/1757-899X/932/1/012128
dc.identifier.uri https://iopscience.iop.org/article/10.1088/1757-899X/932/1/012128/pdf
dc.identifier.uri https://iopscience.iop.org/article/10.1088/1757-899X/932/1/012128
dc.identifier.uri https://hdl.handle.net/20.500.14170/13936
dc.language.iso en
dc.relation.ispartof IOP Conference Series: Materials Science and Engineering
dc.relation.issn 1757-8981
dc.relation.issn 1757-899X
dc.title Experimental investigation of machining parameter on hole quality in drilling Ti-6Al-4V
dc.type Resource Types::text::conference output::conference proceedings
dspace.entity.type Publication
oaire.citation.endPage 7
oaire.citation.issue 1
oaire.citation.startPage 1
oaire.citation.volume 932
oairecerif.author.affiliation Universiti Malaysia Perlis
oairecerif.author.affiliation Universiti Malaysia Perlis
oairecerif.author.affiliation Universiti Malaysia Perlis
oairecerif.author.affiliation Universiti Malaysia Perlis
oairecerif.author.affiliation Universiti Malaysia Perlis
Files
Collections
Conference Publications