Research Output
Sol-gel synthesis and characterization of Ba1-xGdxTiO3+δ thin films on SiO2/Si substrates using spin-coating technique
Analysis of an electrically induced optical waveguide in a c-axis barium titanate thin film
1 - 2 of 2
Publication
Ba1-xGdxTiO3+δ, at x = 0, 0.05, 0.1, 0.15, 0.2, (BGT) thin films have been fabricated on SiO2/Si substrate using Sol-Gel method. The microstructure and surface morphology of the fabricated films have been investigated using X-ray diffraction (XRD) and atomic force microscopy (AFM). The XRD results show that the fabricated films are crystalline with perovskite structure. There is a shifting of the preferred peak at 31.5o to a higher angle as the doping ratio increases suggesting a distortion lattice exists in the films, which could be due to the substitution of Gd3+ ions into Ba-site. The decreasing of lattice constants confirms the substitution of Gd3+ in BaTiO3 lattice structure. The microstrain and dislocation density are found to be increased with the increase of Gd3+ doping, which attributed to the reduction of lattice volume that due to the ionic size mismatch effect. The AFM results show decreasing trend in both average grain size and roughness parameters. Therefore, the microstructure and surface morphology of BGT samples is strongly dependent on the Gd3+ doping concentration that mainly due to the difference ionic radius substitution.
Publication
In this paper, we report our analysis of an electrically generated optical waveguide in a 𝑐- axis barium titanate (BTO) thin film. The waveguide consists of a BTO thin film which is sandwiched between two electrodes. The thin film forms a waveguide when a voltage difference is applied across the electrodes. It is found that the formed waveguide supports both TE and TM modes, with TM modes more tightly confined within the waveguide than TE modes. The possibility to turn the waveguide on and off simply by turning the electric field on and off may prove useful for optical switching.