Wan Khairunizam Wan Ahmad
Thumbnail Image
Preferred name
Wan Khairunizam Wan Ahmad
Official Name
Wan Khairunizam, Wan Ahmad
Alternative Name
Wan, Khairunizam
Ahmad, Wan Khairunizam Wan
Khairunizam, W. A. N.
Main Affiliation
Scopus Author ID
57200576499
Researcher ID
E-6072-2011

Research Output

Filters

3
3
3
Reset filters

Settings
Now showing 1 - 3 of 3
Thumbnail Image
Publication

Improvement of Dissolved Oxygen in Perlis River based on Various Aeration Systems

2021-12-14 , Muhammad Faiz Hilmi Rani , Nur Saifullah Kamarrudin , Shahriman Abu Bakar , Zuradzman Mohamad Razlan , Wan Khairunizam Wan Ahmad , Mohd Sani Mohamad Hashim , Ishak Ibrahim , Anas Abdul Rahman , Ibrahim Z. , Mohd Khairul Faizi Abd Rahman , Mohamad Aniq Syazwan Mohamed Hassan , Abd Manap A.A. , Zainuddin I.F.

Water pollution is closely related to the Water Quality Index (WQI). One of the parameters in classifying WQI is dissolved oxygen (DO) that can be improved by introducing the surface and subsurface aerations. Herein, the Perlis River's water quality was investigated by evaluating the DO's improvement based on various aeration systems. The changes of DO (mg/L) and DO improvement (%) were evaluated during both low and high tide conditions. A total of 9 sets of data collection had been studied by comparing base DO (without running of aeration) and measured DO (with running of aeration) of river. The DO sensor was used to measure the changes of DO in the aeration measurement system. Results found that the DO improvement managed to achieve 74.89%, 10.18%, 35.58%, and 52.45% for water jet, air compressor, commercial venturi, and DIY venturi, respectively. Besides, different behaviour of DO's improvement was observed during low and high tide conditions.

View
Thumbnail Image
Publication

CFD Simulation on Improving Water Quality based on Various Aerator Models to Demonstrate Cost Performance Analysis

2021-12-14 , Nazrul Najmi Norbashah , Muhammad Faiz Hilmi Rani , Nur Saifullah Kamarrudin , Shahriman Abu Bakar , Zuradzman Mohamad Razlan , Wan Khairunizam Wan Ahmad , Mohd Sani Mohamad Hashim , Ishak Ibrahim , Anas Abdul Rahman , Ibrahim Z. , Mohd Khairul Faizi Abd Rahman , Mohamad Aniq Syazwan Mohamed Hassan , Abd Manap A.A. , Zainuddin I.F.

There are many types of aerator that can be used to perform a water treatment process either from air to water or from water to air approaches. Other than focusing on the performance itself, the usage cost of aerator should be forecasted in detail too to have a sustainable and economical method in remediating the polluted water. Therein, the cost performance analysis was demonstrated by performing a computational fluid dynamics (CFD) simulation on improving water quality based on various aerator models. The simulation was focused in a small-scale aeration tank that consists of a mixing chamber, air duct, and a few of bubble diffusers. The improvement of water quality was assessed by calculating the number of gas bubble particles produced by 4 different configurations of aerator model, namely aerator model A, B, C and D, respectively. Results found that the aerator model D (5 bubble diffuser at 620 L/min) produces the highest number of gas particles up to 72.2%. However, the aerator model C (5 bubble diffuser at 300 L/min) was found to achieve the most efficient and sustainable approach based on energy consuming and cost of aerator configuration when compared to the other aerator models.

View
Thumbnail Image
Publication

Development of a Novel Aeration Measurement System to Evaluate Water Treatment Process in a River

2021-12-14 , Muhammad Faiz Hilmi Rani , Nur Saifullah Kamarrudin , Shahriman Abu Bakar , Zuradzman Mohamad Razlan , Wan Khairunizam Wan Ahmad , Mohd Sani Mohamad Hashim , Ishak Ibrahim , Anas Abdul Rahman , Ibrahim Z. , Mohd Khairul Faizi Abd Rahman , Mohamad Aniq Syazwan Mohamed Hassan , Abd Manap A.A. , Zainuddin I.F.

A novel aeration measurement system was developed to evaluate the water treatment process in a river to acquire a more comparable dissolved oxygen value even if various types of aerations are tested. The system comprises of DO sensor, water flowmeter, anemometer, PVC pipes, water pump, air compressor pump, and truck tyre tubes. The PVC pipes consisting of a main drainage hole, 5 holes for dissolve oxygen data collection, 1 hole as the location of aerator system, and connectors were designed as the major part of the system by using Computer Aided Design software. The main drainage hole (horizontal pipe) was designed to be 288.5 cm in length, while the measured holes (vertical pipes) were designed to be 45.7 cm in height. By considering a systematic approach, the designed system is hopefully able to solve measuring issue of dissolved oxygen in moving water and to provide a better evaluation of water treatment process.

View