Mohd Fairul Sharin Abdul Razak
Thumbnail Image
Preferred name
Mohd Fairul Sharin Abdul Razak
Official Name
Mohd Fairul Sharin, Abdul Razak
Alternative Name
Razak, Mohd Fairul Sharin Abdul
Razak, Mohd Fairul Shahrin Abd
Main Affiliation
Scopus Author ID
57219181022

Research Output

Filters

2 1
2
2
Reset filters

Settings
Now showing 1 - 2 of 2
  • Publication
    Preparation of a Visible light Active N-doped TiO2Photocatalyst using Microwave Irradiation Technique
    ( 2020-11-24)
    Nawawi W.I.
    ;
    Mohd Fairul Sharin Abdul Razak
    ;
    Fazeri
    The dye wastewater which directly discharges without treatment process will affect the environment. The semiconductor like titanium dioxide (TiO2) has gained attention as most potential material for photocatalysis process to treat the dye wastewater with act as photocatalyst. However, this semiconductor has their limitation toward the photodegradation under visible light irradiation. In this study, TiO2 has been modified by doping with nitrogen (N) to improve the effectiveness under visible light irradiation. This simple prepared N-doped TiO2 was prepared by mixing of TiO2 powder with urea as N precursor under microwave irradiation instead of using muffle furnace as heating media. The nitogen was chemically bonded with TiO2 as proven by XPS analysis. N-doped TiO2 sample show active under visible light irradiation due to lower band gaps energy of sample observed by UV/Vis-DRS. An active photo response under visible light was observed from N-doped TiO2 with 80 minutes time irradiation to complete the reactive red 4 (RR4) color removal, while no photocatalytic degradation was observed from unmodified TiO2 under the same irradiation.
      1
  • Publication
    Effect of Photoetching Process onto Immobilized PANI/TiO2Films towards Photocatalytic Degradation of RR2 dye
    ( 2020-11-24)
    Mohd Fairul Sharin Abdul Razak
    ;
    Mohd Nazry Salleh
    ;
    Nawawi W.I.
    ;
    Natar N.
    Polyaniline (PANI) and P-25 Titanium dioxide (TiO2) was fabricated as immobilized P-25TiO2/PANI/ENR/PVC film and reported on the photocatalytic study. PANI and TiO2 was immersed into the organic solvent and being coated onto glass plates under influenced of ENR/PVC polymeric binder by using a dip-coating method. It was found that, the removal of RR2 dye nearly good as suspension system after the pre-irradiation process. Based on COD and BET results, it showed that the optimum time of etching process was 7 hours irradiation time. This pre-irradiation process enhanced the removal of dye due to leached out of excessive binder and also exhibit visible light active after insertion of PANI into the immobilized system.
      17  2