Ayob Nazmy Nanyan
Thumbnail Image
Preferred name
Ayob Nazmy Nanyan
Official Name
Ayob Nazmy, Nanyan
Alternative Name
Nanyan, Ayob Nazmy
Nanyan, Ayob Nazmi Bin
Nanyan, A. N.
Main Affiliation
Scopus Author ID
57201667197
Researcher ID
FNW-5877-2022

Research Output

Filters

3
3
Reset filters

Settings
Now showing 1 - 3 of 3
Thumbnail Image
Publication

Current Sensor Based on Planar Rogowski Coil

2021-01-01 , Khalid K.A. , Muhammad Izuan Fahmi Romli , Ayob Nazmy Nanyan , Muhammad Zaid Aihsan , Wan Azani Wan Mustafa , Hasliza A Rahim @ Samsuddin , Alfilh R.H.C.

This paper discusses the design and development of current sensor based on planar Rogowski Coil. A Rogowski coil is a toroid of wire used to measure an alternating current through a cable encircled by the toroid. The aim of this study is to design and develop planar Rogowski as a sensor for current measurement and detection using printed circuit board (PCB). The problem of this project is Rogowski Coil (RC) current sensor has same principle as Current Transformer, but the design is different, especially the RC is developed in PCB. Before starting in development of Rogowski Coil current sensor, a few studies are required to review past research on related topic to develop this project. The winding of Rogowski coil current sensor is design by using design software which is EasyEDA to achieve very good sensitivity for wide bandwidth range of frequency at the lowest cost. Finally, the prototype developed is experimented to get the result. The experimental results are discussed and evaluated regarding the performance of the prototype. The highest induced voltage that detected is 55.3 mV and the lowest induced voltage is 11.1mV. The design of Rogowski sensor is significantly shown the best performance of the current sensor in term of sensitivity and bandwidth.

View
Thumbnail Image
Publication

A Contemporary Review of High Voltage Partial Discharge Detection and Recognition Techniques

2023-07-01 , Bohari Z.H. , Muzamir Isa , Faizah Abu Bakar , Ahmad Zaidi Abdullah , Ayob Nazmy Nanyan , Nasir M.N.M. , Sulaima M.F. , Ahmad E.Z.

This review article provides a summary of the most advanced approaches and advancements in the detection and recognition of high voltage partial discharge (PD). It discusses numerous detecting technologies, such as electrical, acoustic, and optical approaches, as well as their merits and disadvantages. It also discusses current developments in signal processing and pattern recognition algorithms used for PD detection and classification. Lastly, the study covers the challenges and limitations in high voltage PD detection and identification studies, as well as potential future solutions.

View
Thumbnail Image
Publication

The magnetic flux density of various geometries of Rogowski Coil for overvoltage measurements

2020-01-01 , Ayob Nazmy Nanyan , Mohamad Nur Khairul Hafizi Rohani , Muzamir Isa , Afifah Shuhada Rosmi , Ahmad Zaidi Abdullah , Baharuddin Ismail , Haziah Abdul Hamid

Overvoltage phenomenon is the common problem that always occurs in the power system and can cause the electrical system network breakdown, and in some cases, it may explode. The frequent overvoltage also can affect and degrade the lifespan of the electrical power system components and network. Thus, the overvoltage sensor is needed to overcome this problem matter. The Rogowski coil (RC) is one of an inductive coil group, and it is suitable for measuring the alternating current (AC) and transient currents or overvoltage. This paper demonstrated the effect of RC magnetic flux density, B with difference cross-section, geometries sizing and the number of turns by using Finite Element Method (FEM). Commonly, there are three types of RC widely used; rectangular, circular and oval. Each of these cross-sections has different characteristics in term of performance. The results have shown that the rectangular cross-section is better than oval and circular cross-section based on the number of magnetic flux density.

View