Roshazita Che Amat
Thumbnail Image
Preferred name
Roshazita Che Amat
Official Name
Roshazita, Che Amat
Alternative Name
Amat, Roshazita Che
Che Amat, Roshazita
Amat, R. C.
Che Amat, R.
Main Affiliation
Scopus Author ID
55749971400

Research Output
Now showing 1 - 3 of 3
Thumbnail Image
Publication

Investigating the effect of steel wire and carbon black from worn out tyre on the strength of concrete

2024-10 , Norlia Mohamad Ibrahim , Ali Naqiuddin Zamah Shari , Nur Zakiah Anis Abdul Rahim , Nur Liza Rahim , Mustaqqim Abdul Rahim , Roshazita Che Amat , Norshah Aizat Shuaib , György Deak

Technology in concrete is rapidly developing to improve the quality and properties of concrete. One of the many recycled materials is worn-out tyres. Currently, the use of tires is very widespread considering the use of vehicles that increase from time to time. Piles of discarded tires can cause a lot of damage to the environment. So, by using steel wire waste (SWW) as new fiber reinforcement in concrete and with the combination with carbon black (CB), it is hoped that, by doing this, not only it could improve the quality of concrete, but also preserves the environment. Therefore, the objective of this research was, to identify the properties of fresh concrete with the addition of SWW and CB, and also to investigate the physical and mechanical properties of hardened concrete, incorporating of SWW as additional fiber reinforcement and CB. For fresh concrete, workability using a slump test was conducted. Several tests were carried out on the properties of hardened concrete. Among them were compressive strength, flexural strength, splitting tensile strength, and water absorption. The physical appearance of the concrete has also been examined and recorded. There are four batches of concrete which consist of one control batch and three batches of concrete with various weights of SWW which are in the portion of 300 g, 600 g, and 900 g, and the weight of CB is maintained at 300 g for all batches. For workability, all concrete batches with the addition of SWW and CB show acceptable workability. For the case of the density of fresh concrete, samples containing 900 g addition of SWW have the highest density which was 2520 kg/m³, as expected. Results for water absorption show that the lowest value is contributed by the control sample which was 7.6%. For compressive and flexural strength, 300 g addition of SWW has the highest value which was 28.52 MPa for compressive strength and 7.52 MPa for flexural strength. Lastly, for splitting tensile strength, the highest value was also obtained when 300 g addition of SW was added which was 5.4 MPa. To conclude, SWW and CB can be added to concrete to obtain comparable strength of concrete. However, some modifications could be made to both recycle materials to improve concrete performance.

View
No Thumbnail Available
Publication

Influence of cement paste containing municipal solid waste bottom ash on the strength behavior of concrete

2022-01-01 , Roshazita Che Amat , Norlia Mohamad Ibrahim , Nur Liza Rahim , Khairul Nizar Ismail , Hamid A.S.A. , Boboc M.

Cement in construction has become a vital requirement to build up the buildings, which may increase the expenses in construction. Materials that have the potential to replace cement would be proposing. This study used municipal solid waste incineration bottom ash (MSWIBA) as a partial replacement for cement. MSWIBA used in this study was a by-product from the incineration process and had compound content that was almost the same as cement. The treated bottom ash in the range of 0 to 30% and 10% of untreated bottom ash mixture use in this study. Mechanical and physical properties of concrete analysed with a few tests such as slump test, water absorption test, compressive strength test, heat exposure test and residual strength test after heating has proceeded. The workability of fresh concrete was measured by performing a slump test. Based on the compressive strength result, the 10% substitution of treated bottom ash was achieved the highest strength in testing in 7 and 28 days. Meantime, the control concrete obtained the best thermal insulator because of a smaller number of cracks on the surface of the concrete than that bottom ash concrete surface. After heated, the concrete was tested on compressive strength again to investigate the residual compressive strength. The highest residual surpasses gained by 10% bottom ash (treated) as a partial substitution in cement. Based on the overall test carried out, 10% of bottom ash replacement as cement is the optimum amount of bottom ash required to surpass the strength of the control sample.

View
Thumbnail Image
Publication

A Comprehensive Evaluation of Pozzolanic Activity of Ancient Brick Powders Wastes—BPW in Cement Based Materials

2022-01-01 , Moncea Mihaela-Andreea , Deák G. , Dumitru F.D. , Roshazita Che Amat , Norlia Mohamad Ibrahim

The recovery potential of bricks wastes in obtaining environmental friendly materials is sustained by their pozzolanic properties, which can be exploited within a Portland cement—brick powder waste (BPW) system, thus reducing the amount of waste as well as the consumption of raw materials and CO2 emissions from cement factories. These properties were intensively studied and reported in the literature, for their assessment often being used direct analytical methods to highlight the presence of Ca(OH)2 and its subsequent reduction in abundance with time as the pozzolanic reaction proceeds. Since it is more difficult to quantify the pozzolanic activity of calcined clay in a Portland cement /brick powder mixture, for the present work classical determinations, such as thermo-gravimetric analysis (TGA), scanning electron microscopy (SEM) were combined with the individual assessment of BPW in terms of pozzolanicity in order to study the variation of the Ca2+ respectively OH− ions concentration within a BWP—lime saturated solution. SEM analyses showed CH and CSH formation and the DTA curve highlighted a more intense peak around 500 °C after 28 days of hydration, where the Ca(OH)2 decomposition take place. The pozzolanicity test results showed a pronounced decrease of Ca2+ concentration after 28 days.

View