Research Output
Smart self-assembled polymeric-MMT/Moringa Oleifera L. particles by solvent replacement method
Preparation of biodegradable polymeric nanoparticles for pharmaceutical applications using glass capillary microfluidics
1 - 2 of 2
Publication
Obesity, stemming from metabolic syndrome and energy imbalance, is a common health concern characterized by excess energy consumption and fat buildup. Moringa Oleifera L. (MO), known for its anti-obesity properties, is extracted via Soxhlet extraction. MO is extracted using the Soxhlet extraction method. To evaluate the antioxidant properties of MO powder, several analyses were conducted, including the assessment of total phenolic content (TPC), total flavonoid content (TFC), 2,2'-azino-bis (3-ethylbenzothiazoline-6-sulphonic acid) (ABTS) activity, and 2,2-diphenyl-1-picrylhydrazyl (DPPH) activity. The TPC and TFC, DPPH activity, and ABTS activity values were determined to be 386.7 mg GAE/g and 82.33 mg QE/g, 32.86 %, and 49.4 % respectively. To improve drug delivery, the freeze-dried MO powder was encapsulated within a polymeric carrier, poly(-caprolactone) (PCL). Moreover, the incorporation of montmorillonite (MMT) into the MO-loaded PCL nanoparticles enhanced the encapsulation efficiency and drug loading of MO. Nanoprecipitation was employed as a method to produce the nanoparticles, and the effects of four key parameters were studied: the ratio of aqueous phase volume to organic volume (1.5 – 10), stirring speed (400 rpm – 1200 rpm), mass weightage of MO (1 % -5 %), and mass weightage of MMT (2 % - 5 %). Design Expert was utilized for full factorial analysis to assess the impact of these parameters on encapsulation efficiency and drug loading. The optimal formulation was achieved at the ratio of aqueous phase volume to the organic volume of 1.5, stirring speed of 400 rpm, mass weightage of MO at 1 %, and mass weightage of MMT at 5% The expected encapsulation efficiency is 91.33 % and drug loading is 6.49 %.
Publication
The aim of this study was to develop a new microfluidic approach for the preparation of nanoparticles with tuneable sizes based on micromixing/direct nanoprecipitation in a coaxial assembly of tapered-end glass capillaries. The organic phase was 1 wt% poly(ε-caprolactone) (PCL) or poly(dl-lactic acid) (PLA) in tetrahydrofuran and the antisolvent was Milli-Q water. The size of nanoparticles was precisely controlled over a range of 190–650 nm by controlling phase flow rates, orifice size and flow configuration (two- phase co-flow or counter-current flow focusing). Smaller particles were produced in a flow focusing device, because the organic phase stream was significantly narrower than the orifice and remained narrow for a longer distance downstream of the orifice. The mean size of PCL particles produced in a flow focusing device with an orifice size of 200 μm, an organic phase flow rate of 1.7 mL h 1 and an aqueous-to-organic flow rate ratio of 10 was below 200 nm. The size of nanoparticles decreased with decreasing the orifice size and increasing the aqueous-to-organic phase flow rate ratio. Due to higher affinity for water and amorphous structure, PLA nanoparticles were smaller and exhibited a smoother surface and more rounded hape than PCL particles.