Research Output
Effect of bolt configurations on stiffness for steel-wood-steel connection loaded parallel to grain for softwoods in Malaysia
The stiffness of steel-wood-steel connection loaded parallel to the grain
1 - 2 of 2
Publication
Steel-wood-steel connection is widely seen in many applications, such as timber structures. The stiffness of steel-wood-steel connection loaded parallel to grain for softwoods originated from Malaysia was investigated in this study. Numerical models have been developed in ABAQUS to study the stiffness connection. Softwoods of Damar Minyak and Podo have been selected in this analysis. The comprehensive study focused on the effect of bolt configurations on stiffness. Numerical analysis is carried out and the developed model has been validated with the previous study. Further investigations have been made by using the validated model. From this model, numerical analysis of the stiffness values have been made for various bolt configurations, including bolt diameter, end distance, bolt spacing, number of rows and bolts and edge distance. The result shows that the stiffness of bolted timber connections for softwood depends on the bolt diameter, number of rows and bolts, end distance and edge distance. Based on the result, stiffness increased as the diameter of the bolt, end distance, number of rows and bolts and edge distance increased. It is also discovered that the stiffness equation in Eurocode 5 (EC5) is inadequate as the equation only considered parameters which are wood density and bolt diameter. Other connection parameters such as geometry are not considered in the EC5 equation.
Publication
In Eurocode 5, the stiffness equation for bolted steel-wood-steel is stated as a function of wood density and fastener diameter only. In this research, an experimental study on various configurations of tested bolted steel-wood-steel (SWS) connections has been undertaken to predict the initial stiffness of each connection. In order to validate the Eurocode 5 stiffness equation, tests on 50 timber specimens (40 glued laminated timbers and 10 laminated veneer lumbers (LVL)) with steel plates were undertaken. The number of bolts was kept similar and the connector diameter, timber thickness, and wood density were varied. The results obtained in the experimental tests are compared with those obtained from the Eurocode 5 stiffness equation. From the analysis, it is signified that the stiffness equation specified in Eurocode 5 for bolted SWS connections does not adequately predict the initial stiffness. The results from Eurocode 5 stiffness equation are very far from the experimental values. The ratio of stiffness equation to experimental results ranges from 3.48 to 4.20, with the average at 3.77, where the equation over-predicted the experimental stiffness value for the connection. There is a need to consider or incorporated other parameters such as geometric configurations in Eurocode 5 stiffness equation to improve the ratio with the experimental data.