Research Output
The simulation analysis of piezoelectric transducer with multi-array configuration
Performances of Multi-Configuration Piezoelectric Connection with AC-DC Converter in Low Frequency Energy Harvesting System
1 - 2 of 2
Publication
Low frequency energy harvesting using piezoelectric is one of promising method on harvesting energy from a free source. This method offered powering low load and remote device application. However, due to its nature which is inconsistency in providing the magnitude of input, specifically in low frequency harvesting, better solution to stable up and increase the converted output is explored widely. There are a few parameter that influences in the piezoelectric output generation. These parameter includes the type of piezoelectric, piezoelectric array configuration, AC-DC converter and etc. The types of the piezoelectric used in this project are the circular piezoelectric. When there is a force (motion) exerted on the piezoelectric disk, electrical charge was produced which initiated the energy conversion. In this research, the configuration of array connection for piezoelectric were investigated. The system is tested with different load configuration in a range of 10 kΩ to 1 MΩ. The design and development of the piezoelectric array variant were series (S), parallel(P), series parallel (SP) and parallel-series (PS). The observation emphasized on finding the best types of piezoelectric array configuration in producing optimum output of the harvested power. The simulation part consists of designing, simulating and analysing the result are done by using PSIM software. For validation of the simulation result, the implementation design of the hardware prototype that supplies pressure to piezoelectric have been done. In conclusion, a proper implementation of piezoelectric array configuration will produce optimum power output which can fulfil the minimum requirement of energy for powering low load device.
Publication
Harvesting energy by capturing vibration from low frequency energy have been explored extensively. In essence, a single piezoelectric transducer or an array of piezoelectric connections are used to convert kinetic energy into electrical energy in order to produce low frequency energy. In this paper, multi-configuration array piezoelectric connections are used to investigate the performances of different converter circuit types in low energy harvesting applications. This research utilized three pieces of circular piezoelectric sensor to test the combinations of array connection. There are four options for the piezoelectric sensor configuration: parallel (P), series (S), parallel-series (PS), and series-parallel (SP) while the full wave bridge rectifier (FWBR), parallel voltage multiplier (PVM), and parallel Synchronized Switch Harvesting on Inductor (P-SSHI) converter circuit are chosen AC-DC converter circuits. The system is assessed using a variety of load configurations, including 10 kω and 1 Mω with a 3 Hz input frequency. In order to produce the highest possible output of collected power, the observation focuses on identifying the ideal combination of array piezoelectric connections with AC-DC converter. The result shows that 3-Parallel (3P) piezoelectric connection obtained a higher power output among the other types of array piezoelectric which was 5.97μW. The FWBR circuit generated the highest output power with 2.42μW for a combination of piezoelectric sensors array of 3P connection with the AC-DC converter.