Research Output
Piezoelectric Array Configuration Technique into Enhance Power Catchment for Sound Energy Harvester System
The effect of amplitude modulation index on harmonic distortion in unipolar SHEPWM inverter
1 - 2 of 2
Publication
The objective of this study is to explore the harvest maximum output changes occurs in piezoelectric transducer when connected in different configuration to produce highest electricity consumption and generate sound energy harvesting system. Acoustic energy is a type of environmental energy source that can be extracted and converted into electrical energy for small-scale energy applications. In this study, the corresponding load resistance for single piezoelectric transducer is 4.5 k$\Omega$, together with a constant vibration source at a frequency of 68 Hz and a 1-g acceleration. The performance of output voltage and power of piezoelectric are evaluated and the optimum output is measured by depending on the connection of the piezoelectric transducer arrangement into series, parallel and series, and parallel which stimulated using Proteus software. The experiment result presented that, when have single piezo, 5 piezo connected in series, and 5 piezo connected in parallel, the output powers are 1.664 mW, 1.671mW and 7.676 mW, respectively. During the combination series and parallel connections, the output power of 3S1P piezo increases to 5.05mW. In a parallel configuration, the output voltage that produced is much higher than a piezoelectric transducer arrangement connected in series connection. The piezoelectric transducer that connected in parallel configurations increases its voltage output from 2.83 V to 13.05 V with the same polarity. The arrangement of piezoelectric transducer in parallel configuration is affordable, with its higher production of a higher power output compared to the arrangement of piezoelectric transducer in series connection. Whereas in terms of power output, the maximum power remains constant in the range of 1.665 to 1.671 mW when three transducers are in series configuration connection with the same polarity. In conclusion, the proper implementation of the piezoelectric array configuration is needed in order to operate the minimum energy for low load devices and promise to accomplish generated optimum power output in harvester system.
Publication
The appearance of low order odd harmonic in the AC power line can be mitigated by projecting a proper switching angle during the conversion of the inverter. The switching angles can be obtained by solving the numerical nonlinear equation using numerous solving techniques and algorithms. Several studies shows the value of harmonic significantly increase whenever the amplitude modulation decrease for the SPWM switching scheme of the inverter. However, this topic has not yet covered in the single-phase SHEPWM inverter. This paper is to study the effect of the amplitude modulation index towards the harmonic distortion in the SHEPWM switching technique. To solve the numerical equations, MATLAB code is used to produce the specific switching angles to drive the inverter by solving the numerical equations. The validation of results thru hardware implementation using EZDSPTMS320F28335 to produce the digital signal for controlling the inverter. The targeted low order harmonic to be eliminated are the 3rd, 5th and 7th and three four amplitude modulation indices will be compared and observed in term of total harmonic distortion. The THD results for amplitude modulations 0.6, 0.7, 0.8 and 0.9 are 17.50%, 15.10%, 13.30% and 10.63%.